Whenever the Stabilizer has worn down to an unacceptable diameter, it can usually be reconditioned to full gauge when returned to ADWOC Stabilizer Redress Shop.

Welding and Brazing Equipment installed in the Stabilzer Redress Shop provides the capability to perform all types of welding and brazing as well as modifications and repair to Oilfield tools and equipment.

Hardfacing of blades is based on:

Hardfacing of Blades is achieved by using one of the following methods:

ADWOC Stabilizer Redress Shop is built to redress up to 26" diameter.

Full Quality Control Procedures are maintained throughout the repairing process.

Hardfacing techniques have been developed to take full count on the chemical composition of the material and the repeated redressing without damage.

Temperature Control of the body during the pre-heat process and throughout the complete redressing procedure.

All information obtained during the process is recorded on the ADWOC Stabilizer Redress Shop Blue Card.

Redressed Stabilizers are:

For maximum effectiveness the shock tool should be placed immediately above the bit to minimize the amount unsprung mass below the tool. Reduced service life and possible sever damage to the shock tool can occur if the tool is not properly located in bottom hole assembly.(see Figure 1)

The jar maybe located in the drill string in either tension or compression but not at the transition point, provided the forces acting on the jar during drilling operations are less than the latch release setting.